Lenze M850 Series

Transport
•
Ensure appropriate handling.
•
Make sure that all component parts are securely mounted. Secure or remove loose
component parts.
•
Only use safely xed transport aids (e.g., eye bolts or support plates).
•
Do not damage any components during transport.
•
Avoid electrostac discharges on electronic components and contacts.
•
Avoid impacts.
•
Check the carrying capacity of the hoists and load handling devices. The weights can be
found in the shipping documents.
•
Secure the load against pping and falling down.
•
Standing beneath suspended loads is prohibited.
The transport weights can be found in the shipping documents!
The motors mounted on the gearbox are somemes equipped with ears. These
are exclusively intended for mounng the motor on/removing the motor from
the gearbox and must not be used for the complete geared motor!
CAUTION!
Danger from pping or falling loads!
Standing beneath suspended loads is prohibited!
▶
Use addional appropriate liing aids, if required, to achieve a direcon of loading which is
as vercal as possible (highest load carrying capacity). Secure liing aids against shiing!
▶
Screw in the transport aids completely. They must have even and full-surface contact!
▶
Transport aids must be loaded vercally in the direcon of the screw axis! Diagonal or
lateral tension reduces the load carrying capacity! Observe data in standard DIN 580!
The thread in the output sha can be used with smaller drives. Larger gearboxes have a
transport thread for eye bolts in accordance with DIN 580 in the gearbox housing as standard.
The eye bolt is not included in the scope of supply!
The posion of the transport thread can be seen in the following representaons.
Transport
15