Lenze MCS 06I41 - Mounting Procedures

Mounng
Transmission elements
•
Fit or remove transmission elements only using suitable equipment.
•
For ng the transmission elements use the center hole in the sha.
•
Avoid impacts and shocks.
•
In case of a belt drive, tension the belt in a controlled manner according to manufacturer
informaon.
•
Be sure to carry out mounng in a manner free from distoron.
•
Compensate minor inaccuracies by suitable exible couplings.
Fastening
•
Use screws with a minimum property class of 8.8.
•
Observe prescribed ghtening torques.
•
Secure against unintended loosening.
•
For alternang loads, we recommend applying anaerobic curing adhesive between ange
and mounng surface.
Mechanical installaon
Mounng
20