LEO ACm60 - User Manual

13 pages

Save Page as PDF

To Next Page

Acquaer Ltd. H-4900, Fehérgyarmat, Szatmári út 11.

CENTRIFUGAL PUMP

Instruction Manual

ACm60 / ACm75 / ACm150 / ACm150B2

Main Page

Questions and Answers

T
Tiffany BennettAug 1, 2025
What to do if LEO Water Pump motor is running but no water comes out?
- J
  John WilsonAug 1, 2025
  If the LEO Water Pump motor runs but no water is discharged, several issues could be the cause. First, check if the pump's rotation is incorrect and invert two-phase wirings of the motor (for three-phase motors). Ensure the pump is completely filled with water. Examine the suction pipe for any leaks, checking the sealing of all joints in the inlet pipelines. Verify that the water level isn't too low and adjust the pump's installation height if needed. Also, check for freezing in the pipeline or chamber and start the pump after the ice has melted. Finally, the impeller may be damaged, in that case it should be replaced.
P
Penny HollandAug 16, 2025
Why won't my LEO ACm60 Water Pump motor start?
- B
  Brian CameronAug 16, 2025
  If the LEO Water Pump motor won't start, there are several potential causes related to the power supply. For single-phase power supplies (three-phase electric motor), check the power switch connection, replace the fuse if it's burned out, and ensure the power lead is tightly connected. Also, inspect the cable for phase failure and repair or replace cables if needed. Other causes may include a burned-out capacitor (replace it with the same type), jammed rotating shaft and bearing (replace the bearing), a jammed impeller (turn the rotating shaft of the fan blade terminal with a screwdriver to let it rotate flexibly or demount the pump body to clear sundries), or a damaged stator winding (replace winding coils).