To Next PageTo Next Page
Need help?Do you have a question about the Leprecon ULD-360DMX and is the answer not in the manual?
Details connecting the ULD-360 dimmer to standard US power systems (120 VAC 60 Hz).
Specifies the maximum ambient air temperature for ULD-360 dimmer operation (less than 40°C).
Outlines the pack limits for ULD-360 DMX (15 Amps) and ULD-360 DMX-HP (15A/30A).
Explains DMX 512 1990 compliance, cable requirements, and DMX chain connection.
Explains the W-DMX system uses 2.4 ghz radio signal and its range.
Describes how the ULD dimmer receives data from W-DMX transmitters and establishes a link.
Details vertical mounting using a pipe clamp and required clearance for airflow.
Explains connecting line cords to 15 Amp circuits with proper circuit breakers.
Describes connecting lamp loads directly to the dimmer outlets via stage pin or Nema connectors.
Explains how to reset the unit to original factory settings using the ENTER switch.
Describes the display of the starting channel address (A.xxx) and DMX address (d.xxx).
Explains setting the default start address (001) and addressing multiple dimmers.
Details setting the mode for each dimmer channel (Ln, Nd, FL, 00-FF).
Explains how the Status Menu cycles through channel states, DMX input, and output levels.
Describes how the ULD-360 protects itself and displays error messages (Er:01, Er:02).
Outlines troubleshooting steps, contact information, and authorized repair procedures.
Details the two-year warranty, what's covered, and exclusions like misuse.
Specifies the use of 5-pin XLR connectors for DMX 512 communication.
Recommends shielded twisted pair cables approved for EIA-422/EIA-485 use.
General