- 8 -
Note:
When the power switch is set to ON position, the camera requires
30-60 seconds for PIR Sensor to initialize.
3. SETUP MODE
In the SETUP mode you can check and change the settings of the
camera with the help of its built-in LCD. These settings, found in the
menu by pressing the MENU key, let you change the photo or video
resolution, switch the time imprint on, and etc.
Moving the power switch to the SETUP position will turn on the LCD
display, and you will see an information screen that shows the time
and date, battery level, camera or video mode, etc.
Shortcut Keys/Functions
As mentioned earlier in "At a Glance", the keypads have secondary,
"shortcut" functions when the camera is switched to SETUP mode:
Press the UP key to quickly set the camera to shoot video clips.
Press the DOWN key to quickly set the camera to take still photos.
4. PLAYBACK ON THE CAMERA SCREEN
Once you have some photos or videos in the Micro SD card, you can
directly playback them on the screen. In the SETUP mode, press the
REPLAY key to playback/stop playing back the photo or video, press
the DOWN key to the previous photo or video, and press UP key to
the next one. Press the OK key play/pause video playing and press
the MENU key to stop video playing. There are more instructions
during the playback reviewing, see the following tips:
Tips 1: For the photos, press the SHOT/OK
key to zoom in/out and use the UP, DOWN,
LEFT and RIGHT key to locate the image
position, MENU key to go back. (How to
identify photos - Please see the
RECTANGLE identifier and megapixel likes
12M on the top-left corner of the screen)
Tips 2: Press the MENU key to manage the
stored photos/videos during scrolling photos
or videos. You can Delete current file/Delete
all files/Activate slide show/Write protect the
photos and videos you want. Press the
MENU key again to go back.
To Next Page
Loading...