What to do if Letsfit T20 pairing fails?
If your Letsfit Headphone fails to pair, put the earbuds back into the charging case and close the lid, then open the case to automatically enter pairing mode. Select "T20" on your Bluetooth device to pair. Ensure the earbuds and device are within 3 feet of each other without obstacles. Also, check for and eliminate any nearby signal interference. Rebooting your Bluetooth device might also help.
How to prevent fast power consumption on Letsfit Headphone?
To prevent fast power consumption with your Letsfit Headphone, close the lid every time you put the earbuds back into the charging case for charging. If the charging case is out of power, manually turn off the earbuds.
Why does my Letsfit T20 connection keep disconnecting?
Your Letsfit Headphone connection might be unstable if you're too far from your Bluetooth device; try moving closer. Obstacles or your body can also block the signal, so remove any obstructions. High-power electronic devices or other Bluetooth devices nearby could also interfere; move away from them or turn them off.
Identifies parts of the charging case including pins, LED, and port.
Identifies parts of the earbuds like touch button, microphone, and contacts.
Step-by-step guide on how to charge the earbuds.
Instructions for pairing earbuds with a Bluetooth device.
Steps to connect earbuds to different Bluetooth devices.
Details on controlling playback and tracks with earbud touch buttons.
Instructions for managing calls using earbud touch controls.
Procedure to reset the earbuds to factory settings.
Guidelines for cleaning earbuds and charging case.
To Next Page
General
