17
TO INPUT THE CURRENT TEMPERATURE AND ALTITUDE: (dP)
1) Press POWER to activate the rangefinder.
2) Press and hold MODE for at least 2 seconds to enter the Quick Set Menu.
3) Verify that TGR is turned on; if TGR is not activated, you will not be able
to enter the current temperature. To activate TGR, see “To Activate TGR”
(page 15).
4) Press and release MODE again; the last saved temperature will be
flashing in the lower portion of the display.
5) While the temperature is flashing, press and release POWER to change
the current temperature setting to match the current conditions. Each
depression of POWER will increase the temperature setting by 5 degrees
until 120 degrees F has been reached, at which time the setting will
return to 30 degrees F and begin increasing again. Press MODE to save
the changes.
6) Press and release MODE again and the last saved current altitude will be
flashing.
To Next Page
Loading...
Need help?
General
