Mounting
Leuze electronic GmbH + Co. KG MSI-SR4B 12
6 Mounting
The safety relay is intended for mounting on a DIN rail in the switch cabinet.
Prerequisites for mounting:
• Switch cabinet with appropriate degree of protection (at least IP54).
• Sufficient space on the DIN rail.
• Arrangement of the protective device acc. to EN ISO 13855-1:2010 and IEC 61496-2:2020.
Snap the safety relay onto the DIN rail.
The safety relay can be connected to the safety sensors.
WARNING
Improper mounting may result in serious injury!
The protective function of the safety relay is only ensured if appropriately and professionally
mounted for the respective, intended area of application.
Only allow competent persons to install the safety relay.
Observe the relevant standards, regulations and these instructions.
To Next Page
