2024/05
ODSL 8
Characteristic curve of analog output
Mounting instructions
There are mounting systems available, which have to be ordered separately from Leuze electronic. Apart from this, the drilled-through
holes and threaded holes are suitable for the individual mounting of the ODSL 8, depending on the area in which it is to be used. When
mounting, do not subject the housing to excessive force.
A Area not defined
B Linearity not defined
C Measurement range
D Object present
E No object detected
F Measurement distance
Preferred entry direction of objects Preferred mounting in connection to objects with structured surface
View through a recess
If the ODSL 8 has to be installed behind a cover, the recess has to
have at least the size of the optical glass cover. Otherwise, a
correct measurement is not possible or can not be guaranteed.
Alignment on measurement objects with reflective surfaces
If the measurement object to be detected has a reflective surface, a
measurement may not be possible depending on the angle in which the
light is reflected by the measurement object's surface. Adjust the angle
between the sensor and the measurement object such that the sensor can
reliably detect the measurement object.
To Next Page
