Level Sense Pro - Alarm Inputs; Temperature and Humidity Alarm; Power Loss Alarm; Float Switch Alarm

5.3 Configure Device Name
By default, the Level Sense Pro is named “New Sensor“ in Portal.
The device name can be modied and is useful if you have multiple
devices in your Portal.
5.4 Update Frequency
Set the update frequency between two minutes (default) and ve
minutes. Conguring for less frequent updates consumes less
Wi-Fi data.
6.0 Alarm Inputs
By default, all sensor inputs are enabled. Disable sensor inputs to suit
your application. Sensors can be re-enabled at a later point.
6.1 Temperature and Humidity Alarm
Congure a safe temperature and humidity range by setting
minimum and maximum safe levels. Alarms will occur when levels
are outside of these bounds.
6.2 Power Loss Alarm
An alarm will occur after 60 seconds of power failure. If Wi-Fi connection
is lost due to widespread power failure or lost Wi-Fi, an alarm message
cannot be sent. However, Portal will send a device oine message after
the device misses multiple consecutive check-ins. Using default settings,
a device oine message is issued within 6-8 minutes of going oine.
Device oine reminders are sent after 24 hours, 3 days, and 7 days of
continued failed check-ins.
6.3 Float Switch Alarm
The oat switch will alarm when water lifts the sensor oat bobber.
6.4 Leak Sensor Alarm
The leak sensor will alarm when the sensor is in
a minimum water pool of 1/8”.
13