Appendix A. DSA-1000 Web Interface Summary
The attribute setting in this web interface is for COM 1 only. COM 2 uses default settings that are unchan-
geable.
Serial Settings
(corresponding to Thermal Printer)
Data Baud Rate
Select the desired baud rate. (The number of characters per
second transferred)
Data Bits
Select the number of bits in each character.
Data Parity
Choose between Even or Odd for error detection, or select
None for no error detection.
Stop Bits
Choose the number of stop bits to be sent at the end of
every character. Electronic devices usually use 1 bit, slower
electromechanical devices use 1.5 bit.
Flow Control
Choose the method of flow control to pause and resume the
transmission of data to coordinate with printer speed. Select
None if flow control is not required.
To Next Page
Loading...
Need help?
General
