Installation
In this manual, "User" refers to whoever has access to the FCS-1030 Network
Camera, and "Administrator" refers to the person who can configure the
Network Camera and grant user access to the camera.
Hardware installation
Please verify that your product package contains all
the accessories listed in the foregoing Package
Contents. Depending on the user’s application, an
Ethernet cable may be needed. The Ethernet cable
should meet the specs of UTP Category 5 and not
exceed 100 meters in length.
Upon powering up, the device runs through a self-test procedure and the front
LEDs will blink between green and red a few times. If self-test passes, the LED
will be green and the Network Camera will standby for getting IP address. After
getting IP Address, the LED will blink green every second. If self-test fails the
red LED will blink several times. Refer to Appendix A for troubleshooting.
Connect the power adapter jack to the Network
Camera before plugging in to the power socket.
This will reduce the risk of accidental electric
To Next Page
Loading...
Need help?
General
