What to do if LevelOne IP Camera system problems remain after reset?
If you continue to experience system problems with your LevelOne IP Camera after performing a reset, restore the factory settings and then reinstall the system.
Critical warnings regarding power, water, heat, sunlight, handling, and environmental conditions.
Instructions for physically connecting the network camera and its components.
Optimizing video quality, frame rate, and bandwidth usage settings.
How to manage root password, add users, and set viewing permissions.
Configuration of IP address, subnet mask, router, DNS, SMTP, FTP, and HTTP.
How to enable and configure motion detection sensitivity and window settings.
Guidance on diagnosing issues, understanding LED indicators, and reset procedures.
Answers to common questions regarding password, video, and network issues.
Critical warnings regarding power, water, heat, sunlight, handling, and environmental conditions.
Instructions for physically connecting the network camera and its components.
Optimizing video quality, frame rate, and bandwidth usage settings.
How to manage root password, add users, and set viewing permissions.
Configuration of IP address, subnet mask, router, DNS, SMTP, FTP, and HTTP.
How to enable and configure motion detection sensitivity and window settings.
Guidance on diagnosing issues, understanding LED indicators, and reset procedures.
Answers to common questions regarding password, video, and network issues.
General| Resolution | 640x480 (VGA) |
|---|---|
| Frame Rate | 30 fps |
| Minimum Illumination | 0.5 Lux |
| Network Interface | 10/100 Mbps Ethernet |
| Operating Temperature | -10°C to 50°C |
| Weight | 300 g |
| Connectivity | Wired |
| Power Supply | 5V DC |
| Compression | MJPEG |
| Lens | 3.6mm fixed |
To Next Page
