LevelOne FCS-1030 - Appendix; Troubleshooting and Status LED

Appendix
A. Troubleshooting
Status LED
After powering up, the Network Camera performs a self-diagnostic to detect
any hardware defects. The following table lists the LED patterns in general. In
case of any fatal error, the LED will blink in a pattern other than those below.
Condition LED color
During self-diagnostic after power on
Blink in interchanged green and red
Ethernet signal is lost Steady red till Ethernet is detected
Before network is setup Steady green till IP address is
confirmed
After network is setup Blink green every second
Network is setup and audio is
disabled
Blink green every 4 seconds
Any hardware failure Other patterns
Reset and restore
There is a button in the back of the Network Camera. It is
used to reset the system or restore the factory default
settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after
reset, restore the factory settings and install again.
RESET: Click on the button.
RESTORE: 1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic
starts.
Restoring the factory defaults will erase any previous settings. Reset or
restore the system after power on.