Viewing system log
Click the link on the configuration page to view the system log file. The
content of the file provides useful information about configuration and
connection after system boot- up.
Viewing system parameters
Click on this link on the configuration page to view the entire system’s
parameter set. The content is the same as those in CONFIG.INI.
Factory default
Click on this link on the configuration page to restore the factory default
settings. Any changes made so far will be lost and the system will be reset to
the initial factory settings. After clicking on the “OK” button and make
confirmation, the system will restart and require the installer program to set
up the network again.
To Next Page
Loading...
