Using the Software CD to configure the camera
Power on your PC and insert the CD-ROM
The setup page should load automatically. If it does not, please
select your CD-ROM drive manually to open the setup page.
Select “Install Software”->” Device Search” (Figure1-1&1-2 )
Run “Devi
ce Search”. (Figure 1-3)
The Device Search will show MAC address and an IP Address
of available LevelOne Network Cameras. Highlight the MAC
address and double click to link to the selected device.(Figure
1-4)
Enter ‘root’ for the name, and leave the password blank.
(Figure 2-1)
The following screen would appear automatically. Click “Next”
and proceed. (Figure 2-2)
Congratulations, you can use the camera through the network
to view the video.(Figure 2-3)
Installing IP CamSecure
Click ”IP CamSecure” and follow the onscreen instruction or refer to
the user’s manual to complete installation.(Figure 3-1)
To Previous Page
Loading...
