Need help?Do you have a question about the LevelOne FCS-3072 and is the answer not in the manual?
General| Lens | Fixed |
|---|---|
| Focal length | 3.6 mm |
| Connectivity | Wired |
| Infrared Cut Filter | Yes |
| Weather Resistance | IP66 |
| Weight | 450g |
| Type | IP Camera |
| Image Sensor | CMOS |
| Sensor Type | CMOS |
| Field of View | H: 86°, V: 44°, D: 104° |
| Viewing Angle | Horizontal: 86°, Vertical: 44°, Diagonal: 104° |
| Video Compression | H.264 |
| Power Supply | DC 12V |
| Protocols | TCP/IP, HTTP, DHCP, DNS, DDNS, RTP, RTSP, SMTP, NTP, UPnP, FTP |
| Night Vision | Yes |
Prepare additional accessories required for installation and drill screw holes if necessary.
Loosen screws and lift to remove the dome cover, noting the attached string and desiccant bag.
Determine cable path (through hole or along surface) and route the network cable.
Insert memory card if needed, then install the camera to the surface using bundled screws.
Follow procedures to waterproof the RJ-45 Ethernet cable connection using the cable gland.
Connect the network cable to a switch or injector and then to a network or PC with power.
Methods for assigning IP addresses to the camera, including DHCP and manual configuration.
To Next Page