1. If you have external devices such as sensors and alarms, make connection
from general I/O terminal block.
2. Use the supplied RJ45 female/female coupler to connect the Network
Camera to a switch. Use Category 5 Cross Cable when Network Camera is
directly connected to PC.
3. Connect the power cable from the Network Camera to a power outlet.
There are several ways to setup the Network Camera over the Internet. The
first way is to setup the Network Camera behind a router. The second way is
to utilize a static IP. The third way is to use PPPoE.
Internet connection via a router
Before setting up the Network Camera over the Internet, make sure you have
a router and follow the steps below.
1. Connect your Network Camera behind a router, the Internet environment is
illustrated as below. About how to get your IP address, please refer to
Software installation on latter pages for details.
To Next Page
Loading...
