LevelOne GEP-0523 - Page 2

2
ENGLISH
Installation
LED Indicator
Connecting Equipment
Step1. Inspect the Power Adapter carefully, and make
sure that it is properly connected to a power
source.
Step2. Plug-in the Power Adapter to the Switch.
Step3. Connect your network devices with the switch
by using Ethernet cable. (e.g. Cat-5e)
Link/Act
Uplink
LED
Status
Description
PWR
Green
Device active
POE
Yellow
PoE function active and
Connected PD is supplied with PoE
OFF
PoE function deactivated or
No PD identified
L/A
Green
Link to port
OFF
Link failure
Blink
Data transfer to port
SPD
Green
Transfer rate is 1000Mbps
OFF
Transfer rate is 10/100Mbps