LevelOne GEP-1070 - User Manual

319 pages

Save Page as PDF

To Next Page

GEP-1070

L2 Managed Gigabit PoE Switch, 802.3at PoE+,

8 PoE Outputs, 2 x SFP

User Manual

V1.0

Digital Data Communications Asia Co., Ltd.

http://www.level1.com

Main Page

Other manuals for LevelOne GEP-1070

Quick Installation Guide34 pages

Questions and Answers

B
Brad MirandaNov 5, 2025
What to do if I cannot connect to my LevelOne Switch using a web browser?
- J
  Justin BennettNov 5, 2025
  If you're unable to connect to the LevelOne Switch using a web browser, ensure the switch is powered on. Also, verify the network cabling between your management station and the switch. Make sure you have a valid network connection to the switch and that the port you're using hasn't been disabled. Be sure the management station has an IP address in the same subnet as the switch’s IP interface to which it is connected. If you are trying to connect to the switch via the IP address for a tagged VLAN group, your management station, and the ports connecting intermediate switches in the network, must be configured with the appropriate tag. Finally, confirm that you've configured the VLAN interface through which the management station is connected with a valid IP address, subnet mask, and default...

Summary

1. Introduction

1.1. Key Features

1.2. Description of Software Features

Details various software features like backup, authentication, and port configuration.

3. Using the Web Interface

4. Configuring the Switch

4.1. System

4.2. Power Reduction

4.3. Thermal Protection

4.4. Ports

Configuration of port connection parameters like speed and duplex.

4.5. Security

Configuration of user access and general security measures.

4.8. Spanning Tree

4.12. Power over Ethernet (PoE)

Configures PoE power, budget, and priorities.

4.14. IEEE 802.1 Q VLANs

Organizes network nodes into separate broadcast domains.

4.18. Quality of Service (QoS)

Specifies packet precedence for traffic buffering.

6. Diagnostics

6.1. Pinging

Issues ICMP ping packets to troubleshoot IP connectivity.

6.2. ICMPv6 Pinging

Sends ICMPv6 echo request packets to test reachability.

6.3. Running Cable Diagnostics

Performs cable diagnostics to diagnose faults and report length.

7. Maintenance

7.1. Restarting the Switch

7.2. Restoring Factory Defaults

7.3. Software

A. Software Specifications

A.1. Software Features

B. Troubleshooting

B.1. Accessing the Management Interface

B.2. Accessing the Web Page

B.3. Factory Default Reset

Steps to reset the switch to factory default settings.

B.4. Using System Logs

LevelOne GEP-1070 Specifications

General

Layer	Layer 2
PoE Standard	IEEE 802.3af/at
Jumbo Frame Support	9KB
Packet Buffer Memory	1.5MB
Dimensions	280 x 180 x 44 mm
Power Consumption	80W maximum
PoE Ports	4