174
PARAMETERS
These parameters are displayed:
◆ PVLAN ID – Private VLAN identifier. (Range: 1-4095)
By default, all ports are configured as members of VLAN 1 and PVLAN 1. Because all of
these ports are members of 802.1Q VLAN 1, isolation cannot be enforced between the
members of PVLAN 1. To use PVLAN 1 properly, remove the ports to be isolated from
VLAN 1. Then connect the uplink ports to the local servers or other service providers to
which the members of PVLAN 1 require access.
◆ Port Members – Port identifier.
WEB INTERFACE
To configure VLAN port members for private VLANs:
1. Click Configuration, Private VLANs, PVLAN Membership.
2. Add or delete members of any existing PVLAN, or click Add New Private VLAN and mark
the port members.
3. Click Save.
Port Isolation
Use the Port Isolation Configuration page to prevent communications between customer
ports within the same private VLAN.
Ports within a private VLAN (PVLAN) are isolated from other ports which are not in the same
PVLAN. Port Isolation can be used to prevent communications between ports within the
same PVLAN. An isolated port cannot forward any unicast, multicast, or broadcast traffic to
any other ports in the same PVLAN.
PATH
Configuration \ Private VLANs \ Port Isolation
To Next Page
Loading...
