166
WEB INTERFACE
To configure the port-specific PoE IP checking:
1. Click Configuration, PoE, Autochecking.
2. Select the port for enabling PoE IP checking.
3. Enter the corresponding IP address, Interval Number, Failure Action, Retry Number, and
the desired Reboot Time.
4. Click Save.
4.13. MAC Address Table
Use the MAC Address Table Configuration page to configure dynamic address learning or to
assign static addresses to specific ports.
Switches store the addresses for all known devices. This information is used to pass traffic
directly between the inbound and outbound ports. All the addresses learned by monitoring
traffic are stored in the dynamic address table. You can also manually configure static
addresses that are bound to a specific port.
PATH
Configuration \ MAC Table
Figure 66: MAC Address Table Configuration
PARAMETERS
These parameters are displayed:
To Next Page
Loading...
