77
WEB INTERFACE
To configure RMON Event table:
1. Click Configuration, Security, Switch, RMON, Event.
2. Click Add New Entry to create a new entry. The entry index key is ID.
3. Specify the ID, Data Source, Desc, Type, Community settings.
4. Click Save.
Network Security
Limit Controls
Use the Port Security Limit Control Configuration page to limit the number of users accessing
a given port. A user is identified by a MAC address and VLAN ID. If Limit Control is enabled
on a port, the maximum number of users on the port is restricted to the specified limit. If this
number is exceeded, the switch makes the specified response.
PATH
Configuration \ Security \ Network \ Limit Control
Figure 29: Port Limit Control Configuration
PARAMETERS
The following parameters are displayed on the Port Limit Control
To Next Page
Loading...
