186
◆ PCP/DEI – Shows the mapping options for classified (PCP, DEI) to (QoS class, DP level)
values when Tag Classification is Enabled.
◆ QoS class – Controls the mapping of classified (PCP, DEI) to QoS class values when Tag
Classification is Enabled. (Range: 0-7; Default: 0)
◆ DP level – Controls the mapping of classified (PCP, DEI) to DP level (drop precedence)
values when Tag Classification is Enabled. (Range: 0-1; Default: 0)
WEB INTERFACE
To set the basic QoS parameters for a port:
1. Click Configuration, QoS, Port Classification.
2. Set any of the ingress port QoS classification parameters.
3. Click Save.
To configure tag classification for tagged frames:
1. Click Configuration, QoS, Port Classification.
2. Click on the value displayed in the Tag Class field.
3. Set the tag classification mode to Disabled to use the default QoS class and DP level for
tagged frames, or to Enabled to use the mapped versions of PCP and DEI for tagged
frames.
4. Click Save.
Configuring Port Policing
This page allows you to configure the policing settings for all switch ports.
PATH
Configuration \ QoS \ Port Policing
Figure 77: Configuring QoS Ingress Port Policers
To Next Page
Loading...
