195
PARAMETERS
These parameters are displayed:
◆ DSCP – DSCP value in ingress packets. (Range: 0-63)
◆ Trust – Controls whether a specific DSCP value is trusted. Only frames with trusted DSCP
values are mapped to a specific QoS class and drop level (DPL). Frames with untrusted
DSCP values are treated as non-IP frames.
◆ QoS Class – QoS value to which the corresponding DSCP value is classified for ingress
processing. (Range: 0-7; Default: 0)
◆ DPL – Drop Precedence Level to which the corresponding DSCP value is classified for
ingress processing. (Range: 0-1, where 1 is the higher drop priority; Default: 0)
WEB INTERFACE
To configure DSCP-based QoS ingress classification settings:
1. Click Configuration, QoS, DSCP-Based QoS.
2. Specify whether the DSCP value is trusted, and set the corresponding QoS value and DP
level used for ingress processing.
3. Click Save.
Configuring DSCP Translation
Use the DSCP Translation page to configure DSCP translation for ingress traffic or DSCP re-
mapping for egress traffic.
PATH
Configuration \ QoS \ DSCP Translation
Figure 84: Configuring DSCP Translation and Re-mapping
To Next Page
