196
PARAMETERS
These parameters are displayed:
◆ DSCP – DSCP value. (Range: 0-63)
◆ Ingress Translate – Enables ingress translation of DSCP values based on the specified
classification method.
◆ Ingress Classify – Enable Classification at ingress side as defined in the QoS Port DSCP
Configuration table.
◆ Egress Remap DP0 – Re-maps DP0 field to selected DSCP value. DP0 indicates a drop
precedence with a low priority.
◆ Egress Remap DP1 – Re-maps DP1 field to selected DSCP value. DP1 indicates a drop
precedence with a high priority.
WEB INTERFACE
To configure DSCP translation or re-mapping:
1. Click Configuration, QoS, DSCP Translation.
2. Set the required ingress translation and egress re-mapping parameters.
3. Click Save.
To Next Page
Loading...
