LevelOne GEP-1070 - Displaying Poe Status; Poe Configuration Status

275
5.11. Displaying PoE Status
PoE Configuration Status
Use the Power over Ethernet Status to display the status for all PoE ports, including the PD
class, requested power, allocated power, power and current used, and PoE priority.
PATH
Monitor \ PoE \ Configuration
Figure 139: Power over Ethernet Status
PARAMETERS
These parameters are displayed:
◆ Local Port – The port on this switch which received the LLDP frame.
◆ PD class – Each PD is classified according to the maximum power it will use. The PD
classes include:
■ Class 0: Max. power 15.4 W
■ Class 1: Max. power 4.0 W
■ Class 2: Max. power 7.0 W
■ Class 3: Max. power 15.4 W
■ Class 4: Max. power 30.0 W
◆ Power Requested – Amount of power the PD wants to be reserved.
◆ Power Allocated – Amount of power the switch has allocated for the PD.
◆ Power Used – How much power the PD is currently using.
◆ Current Used – How much current the PD is currently using
◆ Priority – The port's configured priority level.
◆ Port Status – PoE service status for the attached device.