175
Figure 70: Port Isolation Configuration
PARAMETERS
These parameters are displayed:
◆ Port Number – Port identifier.
WEB INTERFACE
To configure isolated ports:
1. Click Configuration, Private VLANs, Port Isolation.
2. Mark the ports which are to be isolated from each other.
3. Click Save.
4.16. VCL Configuration
MAC-based VLAN
Use the MAC-based VLAN Membership Configuration page to configure VLAN based on
MAC addresses. The MAC-based VLAN feature assigns VLAN IDs to ingress untagged
frames according to the source MAC addresses.
When MAC-based VLAN classification is enabled, untagged frames received by a port are
assigned to the VLAN which is mapped to the frame’s source
MAC address. When no MAC address is matched, untagged frames are assigned to the
receiving port’s native VLAN ID (PVID).
PATH
Configuration \ VCL \ MAC-based VLANs
Figure 71: Configuring MAC-Based VLANs
To Next Page
Loading...
