LevelOne GEP-1070 - Displaying LLDP-MED Neighbour

267
Table 14: System Capabilities
I D Basis
Reference
Repeater
IETF RFC 2108
Bridge
IETF RFC 2674
WLAN Access Point
IEEE 802.11 MIB
Router
IETF RFC 1812
Telephone
IETF RFC 2011
DOCSIS cable device
IETF RFC 2669 and IETF RFC 2670
Station only
IETF RFC 2011
When a capability is enabled, the capability is followed by (+). If the capability is disabled, the
capability is followed by (-).
◆ Management Address – The IPv4 address of the remote device. If no management
address is available, the address should be the MAC address for the CPU or for the port
sending this advertisement.
If the neighbor device allows management access, clicking on an entry in this field will re-
direct the web browser to the neighbor’s management interface.
WEB INTERFACE
To display information about LLDP neighbours, click Monitor, LLDP, Neighbors.
Displaying LLDP-MED Neighbour
Use the LLDP-MED Neighbour Information page to display information about a remote
device connected to a port on this switch which is advertising LLDP-MED TLVs, including
network connectivity device, endpoint device, capabilities, application type, and policy.
PATH
Monitor \ LLDP \ LLDP-MED Neighbours
Figure 135: LLDP-MED Neighbour Information