LevelOne VOI-8002 - Page 41

4
k. Call Waiting：Enable or Disable the call waiting function。
 Enable: During Talk, you can answer another phone call and
hold the original conversation. When some one call in when you
are busy on another phone call , you will hear a du-du call waiting
signal, please use flash key on your phone to hold the original call
and answer the incoming call, press again flask key will switch
back the original call party.
 Disable: Disable the Call waiting function. The gateway will reply
the busy to remote side when the line is on used.
Index
Area Code
Auth
Strip
Prefix Maximum
Minimum
From
To
LineNo
RS Verify
CallWaiting
Alert Profile Forward Delete
1
1
□
□
Rs1 Enable 60H60H60H Delete
2
2
□
□
Rs 61H61H 61HDelete
3
3
□
□
rs3_2_1
62H62H62H Delete
l. Alert: Control the Ring Back tone generate timing:
 Mode 0: When this VoIP Gateway get ring back tone from phone line, it
will send the ring Alert signal to remote VoIP Gateway for generate ring
back tone.
 Mode 1: Before this VoIP Gateway dial to phone line, it will send the
ring Alert signal to remote VoIP Gateway for generate ring back tone.
 Mode 2: After this VoIP Gateway finish dial out number to phone line, it
will send Connect OK signal to remote VoIP Gateway.
m. Profile: Define the optional special VoIP parameters when received on this
destination. Please input the name you defined on the profile list (/VoIP
Setup/Routing Setup/Routing Profile/).
Example: if user set the VoIP Call in & Routing Profile like below:
Index
Area Code
Strip
Prefix Maximum
Minimum
From
To
LineNo
Gatekeeper
Alert Profile Forward Delete
1
1
PF1 63H63H63HDelete
2
2
PF2 64H64H64HDelete
3
3
65H65H65HDelete
Index
Name
VAD
CODEC
H.245
Tunneling
DTMF
Relay
T.38
FAX Relay
Package
Frame
Q.931
Fast
Start