LevelOne WBR-6002 - Page 80

Advanced Features
77
Outgoing
Ports
 Type - Select the protocol (TCP or UDP) used when you
send data to the remote system or service.
 Start - Enter the beginning of the range of port numbers
used by the application server, for data you send to it. If
the application uses a single port number, enter it in both
the "Start" and "Finish" fields.
 Finish - Enter the end of the range of port numbers used
by the application server, for data you send to it. If the
application uses a single port number, enter it in both the
"Start" and "Finish" fields.
Incoming
Ports
 Type - Select the protocol (TCP or UDP) used when you
receive data from the special application or service.
(Note: Some applications use different protocols for out-
going and incoming data).
 Start - Enter the beginning of the range of port numbers
used by the application server, for data you receive. If the
application uses a single port number, enter it in both the
"Start" and "Finish" fields.
 Finish - Enter the end of the range of port numbers used
by the application server, for data you receive.