N_One Wireless CardBus Adapter
Advanced Settings Screen
Once you have created a profile, as described above, the Advanced Settings tab will
be available on the Profile Manager screen.
Note: Advanced settings only available when 11b/g wireless mode has been se-
lected.
Figure 10: Advanced Settings Screen
Data - Advanced Settings Screen
Do not change
settings
Enable this check box if you don’t want to modify the settings
in this screen.
Preamble
(2.4GHz)
Normally, this should be left at "Auto".
The option “Short”, “Long” preamble and header is intended
for special application and equipment.
Transmit Rate
Use this to manually set the speed, if desired. The default is
"Auto".
Fragment Thresh-
old
The default value is 2346. In some cases, you may be able to
improve performance by adjusting this value.
RTS/CTS Thresh-
old
The default value is 2346. In some cases, you may be able to
improve performance by adjusting this value.
802.11n
Enable 802.11n
Network
802.11n wireless network connectivity
11
To Next Page
Loading...
