5 6
USING YOUR HUMIDIFIER
1.
[Figure 2.1]
2.
mist. [Figure 2.2]
3.
4. Rotate the Control Knob counterclockwise to
Figure 2.1 Figure 2.2
Note: If there is no water in the tank or the
tank is removed, the humidier will stop
misting and the Rell Indicator Light will turn
on. Rell the tank and properly place it on the
base to use your humidier.
Note: Do not immerse the air outlet or air
inlet in water.
Figure 2.3
Figure 2.4
Figure 2.5
Important Tips
there is too much water in the base chamber,
• Never
chamber. [Figure 2.3]
• Only add water to the water tank. The
amount of water into the base chamber.
•
[Figure 2.4]
release too much water into the base chamber.
•
it, and remove the water tank.
•
there is too much water in the base chamber.
Pour out extra water if water is over the max
line. [Figure 2.5]
Note: The max water line is only for this purpose.
Do not pour water into the base chamber.
Figure 3.1
Figure 3.2 Figure 3.3
CARE & MAINTENANCE
Note:
• All maintenance should be done on a water-
resistant surface, such as a kitchen counter.
• Change the water daily to avoid bacteria growth.
• Use a tissue or cloth to clean the nozzle regularly.
• If not using the humidier for 3 days or longer,
do not leave water inside. Clean and dry the
humidier instead.
Note: When pouring out water, hold down the
Note:
• The water tank, cover, water lter
and housing, mist tube, and oat are
dishwasher safe. Make sure the water
temperature is below 158°F / 70°C
• Do not wash the base in the dishwasher,
as the electronics will be damaged.
• Never immerse the base in water or liquid.
• Do not immerse the air outlet or air inlet in
water.
Cleaning
For detailed dishwasher cleaning instructions,
contact Customer Support
3. Remove the water tank from the base and
chamber. [Figure 3.1]
1.
2. Remove the water tank cover.
Cleaning (cont.)
1
4.
[Figure 3.2]
5.
be removed.
6.
[Figure 3.3]
a.
dishwasher. Do not wash the base in the
dishwasher.
7. Rinse the base chamber with room temperature
water.
1.
it counterclockwise and lifting it out. [Figure 3.4]
2.
white vinegar. [Figure 3.5]
Figure 3.4 Figure 3.5
Descaling Your Humidifier
Figure 3.8 Figure 3.9
Figure 3.6 Figure 3.7
3. Replace the tank cover and swish the vinegar
around the tank. [Figure 3.6]
4. Place the tank on the base and soak for
[Figure 3.7]
5. Remove the tank, remove the tank cover, and
[Figure 3.8]
6. Flip the tank over and remove the noise
silencer. To remove the noise silencer, press
[Figure 3.9]
8.
Reassembling
7.
[Figure 3.10] and
allow the shaft to be removed. [Figure 3.11]
Figure 3.10
Figure 3.11
Product
Model
For your own reference, we strongly recommend that you record
your order ID and date of purchase.
Date of Purchase
Order ID
WARRANTY INFORMATION
87
9
Figure 3.13
Figure 3.16 Figure 3.17
3.
a.
facing up. [Figure 3.16]
b. Insert the smaller prong into the closed
[Figure 3.17]
c. Place the larger prong into the open
Ushaped
4.
5.
the tank cover on the water tank.
Storing
The Water Filter Assembly
clogging the water outlet valve and entering the
base chamber. Large particles in the water can cause
needs to be replaced. For more information, contact
Customer Support
Figure 3.15
Figure 3.14
Descaling Your Humidier (cont.)
8.
silencer in a small container. Fill with enough
[Figure 3.12]
Reassembling
1. Flip the water tank over and place the noise
silencer back into the tank. [Figure 3.14]
2.
tank and rotate it clockwise to secure it in place.
[Figure 3.15]
Problem Possible Solution
Humidier doesn’t
turn on, or turns o
unexpectedly.
Humidier produces
an unusual smell.
Care & Maintenance
Humidier makes
a loud or unusual
noise.
Getting Started
Set mist level to a lower setting.
TCustomer Support
White scale (mineral
buildup) appears
around the humidier.
mineral content.
Care & Maintenance
Water leaks from the
humidier.
Make sure the silicone sealing ring around the water outlet valve is secure.
Do not
Check the water tank for leaks. If there are leaks, contact Customer Support
Condensation forms
around humidier or
windows.
in the room.
Mold grows inside
the humidier.
Care & Maintenance
Rell Indicator Light
turns on.
Fill the water tank.
Customer Support
Problem Possible Solution
Little or no mist
comes out.
Turn the mist level to a higher setting.
Fill the water tank.
Make sure the nozzle is not blocked or clogged.
detergent.
Figure 3.12
Levoit Limited Product Warranty
up to date with important product information such as product updates,
limited warranties, usage and maintenance recommendations, and
Two (2) Year Limited Consumer Product Warranty
from defects in material and workmanship for a period of 2 years from
the date of original purchase
Your Limited Warranty Benefits
store credit in the amount of the purchase price.
Who is Covered?
the product, regardless of whether the product transferred ownership
purchaser must provide verification of the defect or malfunction and proof
Be Aware of Unauthorized Dealers or Sellers
Please be aware, products purchased from an unauthorized website
our Customer Support Team via support@levoit.com.
What’s Not Covered?
• Normal wear and tear, including parts that might wear out over
•
illegible.
• If the model number, serial number or production date code on
the product has been altered, removed or made illegible.
• If the product has been modified from its original condition.
• If the product has not been used in accordance with directions
and instructions in the user manual.
•
the user manual.
•
•
• Damages or defects occurring during commercial use, rental use,
• If the unit has been damaged, including but not limited to
•
• Damages or defects exceeding the cost of the product.
Claiming Your Limited Warranty Service in 5 Simple Steps:
period.
of-purchase.
DO NOT
before contacting us.
Contact our Customer Support Team via support@levoit.com
5.
Sole and Exclusive Remedy
Disclaimer of Limited Warranties
Limitations of Liability
OR
INDIRECT.
OTHER RIGHTS YOU MAY HAVE
CHANGES TO THIS POLICY
THIS DEVICE COMPLIES WITH PART 18 OF THE FCC RULES.
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
Federal Communication Commission Interference Statement
Such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular
• Reorient the receiving antenna of radio or television.
•
•
•
9. Use the cleaning brush and a soft cloth to remove
scale from all parts.
10.
[Figure 3.13]
11.
oat to ensure that it does not fall out of the
base chamber.
To Next Page
Loading...
