11
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
A. lights up.
1. Replace the filter.
2. Turn on the air purifier.
3. Press and hold for 3 seconds.
4. will turn o when successfully
reset.
B. The filter was changed before
lit up.
1. Press and hold for 3 seconds.
This will turn on .
2. Press and hold again for 3
seconds.
3. will turn o when successfully
reset.
1. Unplug the air purifier. Flip the air purifier
over and remove the filter cover (see
Getting Started, page 6).
2. Remove the old filter.
3. Clean out any remaining dust or hair
inside the air purifier using a vacuum
hose. Do not use water or liquids to
clean the air purifier. [Figure 3.2]
4. Unwrap the new filter and place it into the
housing (see Getting Started,
page 6).
5. Replace the cover. Plug in the air purifier.
6. Reset the Check Filter Indicator (see
page 10).
Replacing the Filter
Figure 3.2
If not using the air purifier for an extended
period of time, wrap both the air purifier and
the filter in plastic packaging and store in a
dry place to avoid moisture damage.
Storage
KEEPING THINGS CLEAN (CONT.)
To Next Page
Loading...
