13
If your problem is not listed, please contact Customer Support (see page 15).
TROUBLESHOOTING (CONT.)
Problem Possible Solution
Poor air purification quality.
Tap to increase the fan speed.
Make sure no objects are blocking the sides or top of the
air purifier (the inlet or outlet).
Make sure the filter is removed from its packaging and
properly in place (see page 6).
Close doors and windows while using the air purifier.
If the room is larger than 219 ft² / 20 m² air purification will
take longer.
Replace the filter (see page 11).
is still on after replacing
the filter.
Reset the Check Filter Indicator (see page 11).
has not turned on within 8
months.
is a reminder for you to check the filter and will light
up based on how long the air purifier has been used (see
page 11). If you don’t use your air purifier often, will
take longer to turn on.
turned on before 6 months. is a reminder for you to check the filter and will light
up based on how long the air purifier has been used (see
page 11). If you run your air purifier frequently, will
turn on sooner.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT – PART 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.