Lewmar EVO 45 - Installation

4
OCEAN KIT
40 48040055
46 48046055
48 48048055
50 48050055
54 48054055
58 48058055
65 48065055
A B
C
EVO® KIT
40
48540055
45 48545055
50 48550055
55 48555055
65
48565055
A B
C
360˚
-5° to -10°
-5° to -10°
3.3-2
3. 3-1
GB
3. Installation
3.2 Preparing manual winch for electric conversion
IMPORTANT: Check existing winch location is suitable for positioning motor/gearbox, see section 3.4.
• Remove the winch from the deck, replace centre stem with supplied kit centre stem. Reassemble winch, fix
power drive base to the centre stem and fit motor/gearbox as instructed in this manual.
3.3 Above deck preparation electric/hydraulic winch
IMPORTANT: Always keep in mind the space available below deck for the motor/gearbox or hydraulic drive unit.
Plan location carefully before drilling any holes and allow for the following:
1. 360 degree rotation of manual operating handle.
2. Lewmar recommend that the rope enters onto the drum at an angle of –5° to –10° to the base axis of the
winch. To achieve this angle it may be necessary to use a base wedge when installing the winch.
3.1 Electric conversion kit
1. Ocean Wavespring manual winches manufactured from 1992 and EVO® manual winches can be converted
to electric powered operation with a Lewmar conversion kit consisting of the following:
• Centre stem (A) and a power drive base (B).
• Then specify a suitable Lewmar motor/gearbox (C) to form the basic electric winch deck unit conversion.