3
Electric/Hydraulic TT Thruster 140 - 300
GB
Issue 2. Electric/hydraulic TT thruster 140 - 300.
Contents
Introduction 4
Product support 4
Important information about this manual 4
Approvals 4
Safety notices 4
General 4
Thruster supply 4
Fitting 4
Electrical 4
1. Installation 5
1.1 Choosing location 5
1.2 Preparing the hole for the tube 5
1.3 Preparing for fi tting the thruster 6
1.4 Installing hub unit and saddle models
140TT & 185TT 7
1.5 Gearbox position - 185TT only 7
1.6 Propeller assembly - all models 7
1.7 Installing hub unit and saddle models
250TT & 300TT 8
1.8 Electric motor unit support 9
1.9 Installing electric motor unit model
140TT & 185TT 9
1.10 Installing electric motor unit model
250TT & 300TT 9
1.11 Installing hydraulic motor unit model
185TTH to 300TTH 10
1.12 Final checks - All models 10
2. Electrical wiring installation 11
2.1 Typical electrical layout model
140TT 2.0 kW only 11
2.2 Typical electrical layout models
140TT 2.2 kW and 185TT 11
2.3 Typical electrical layout models
250TT & 300TT 12
2.4 Electric motor terminal connections 12
2.5 Battery cable connections 13
2.6 Correct cable sizes 13
2.7 Electrolytic test 14
2.8 Installing control panel - all models 14
2.9 Final checks 15
3. Operating your thruster 15
3.1 140TT 2.0 kW 15
3.2 140TT 2.2 kW to 300TT 15.0 kW
operation and safety features 16
4. Servicing your thruster 17
4.2 Changing drive pin 140TT or 185TT 17
5. Weight & specifi cations 18
5.1 Electric 18
5.2 Hydraulic 18
6. Parts list 19
6.1 Model 140TT 2.0 kW 12 V 19
6.2 Model 140TT 2.2 kW 12 V 19
6.3 Model 185TT/H 3.0 to 6.0 kW 12 & 24 V 20
6.4 Model 250TT/H 8.0 kW 24 V 21
6.5 Model 300TT/H 10.8 to 15.0 kW 22
6.6 Accessories 23
7. Dimensions 24
7.1 Electric 24
7.2 Hydraulic 24
8. Fault fi nding 25
9. Cutting templates 26
10. Lewmar limited warranty 27
T187
To Next Page
Loading...
