LexiconBasic Operation
8
Selecting and Loading Programs
MPX 500 programs are organized into 24 Banks plus a User Bank. (The programs are described in
detail later in this manual.) When powered on, the unit will display and load the last program used.
To display any other MPX 500 program, simply turn the front panel PROGRAM knob. The knob will
progressively select the rest of the programs in the current Bank, then proceed through each of the
remaining Banks. To jump between Banks, push the PROGRAM knob in while turning.
If the selected program is not the currently loaded program, the Load LED will light. After four seconds,
the display will revert to showing the current program, but the Load LED will remain lit to indicate that
the last selected program is cued for loading. The number of the cued program will appear highlighted
to the left of the name of the current Bank on the display. To load the cued program, press Load.
An AutoLoad feature is available which will cause selected programs to load automatically 3/4 second
after the knob stops turning. (See
System Mode
for information on activating this and other System
mode parameters.)
Push for Bank
Load
Bypass
PROGRAM
Push for Bank
Load
Bypass
PROGRAM
Turn PROGRAM to cycle through
all of the MPX 500 programs.
To select a specific program Bank, push
the PROGRAM knob in while turning.
Load
When the selected program is different from the
currently running program, the Load LED will light.
Press to load the selected program.
To Next Page
Loading...
