Lexicon MPX 500 - MIDI Operation; MPX 500 MIDI Behavior

MPX 500 User Guide MIDI Operation
47
MIDI Operation
MPX 500 MIDI Behavior
The MPX 500 “learns” Program Change and Continuous Controllers in its Learn Mode. All of the
parameters controlled by the front panel Edit knobs, as well as the Bypass and Tap buttons are
supported.
As all MPX 500 messages use a single, selectable MIDI Channel, before using any of the MIDI control
features, you should go to System Mode and select the MIDI Channel you want to use. (See System
Parameters .)
Any of the 16 parameters controlled
by the Edit knobs can be patched
to Continuous Controllers.
Program Change messages can
also be used to load programs.
Edit Page 4
Input Trim
Power
Push for Bank
Learn
Edit Pages
1234
12 34
Edited –
System
Load
Bypass Store Tap/Cancel
Select Change
24-Bit Dual Channel Processor
MPX 500
EDIT PROGRAM
209
Pitch-Reverb
Adjust Pitch 1
3rd4th-Room
Pitch
Reverb
146bpm(p)
DelayL Mix 0(g)S44
Edit Page 3
Edit Page 2
Edit Page 1
CCs and Program Change
messages can be patched to
Bypass and Tap.