2-4
Basic Operation
Lexicon
INFO
The PCM 91 offers an extensive set of
informative display messages which can be
activated from the front panel.
The front panel switches perform various
functions when pressed. Most of these
functions are activated on release of the
button. If you want to know more about the
function of a particular button (without
actually executing any action) press and
hold the button down. While you are
holding down the button, an explanatory
message will appear on the display. The
activation of an Info message overrides the
normal function of the button, so that no
action is taken on release.
HISTORY OF EFFECTS LOADED
The PCM 91 allows you to review the last ten effects loaded. This
is useful when you want to return to an effect you were using
earlier, but can't remember its name or location. This History view
is accessed from Program Banks or Register Banks mode by
simultaneously pressing and releasing both the Program Banks and
the Register Banks buttons. The display pictured at the right will
appear.
The label 1 back in the example, means that the effect shown on
the bottom line was running just before the current effect. Turning
SELECT to the right will scroll you through the stored list of effects,
all the way to 10 back. Press Load/✱ to load any of the displayed
programs. Press any key to exit.
The top line of the display shows the position in the
review list of the displayed effect.
The bottom line of the display shows the bank and
matrix location and the name of the effect.
History: 1 back
XX X.X ✱XXXXXXXXXXX
Note that loading programs from the review display does not
update the historical record, nor does loading from MIDI, Chain or
Map. Only program loads from Programs Banks or Register Banks
mode are recorded.
Up
Program
Banks
Register
Banks Edit Control Tempo
Down
Load
Compare Bypass Tap
❊
Store
Displays the currently loaded effect
name, bank, and matrix location.
Displays the current tempo and the
clock source (MIDI or internal).
Displays the type of system
bypass currently selected,
and the current status
(on or off).
Inactive until an effect has been
altered, then displays "Press to
hear stored effect."
Displays action needed to
perform a store operation or
Memory Protect message when
store function is disabled.
Displays the current function
assigned to the Down button
and the Select knob.
Displays the current function
assigned to the Up button
and the Adjust knob.
Info messages are displayed when a button is pressed
and held down. Generally, info messages describe the
function of a button, or provide current status information.
To Next Page
Loading...
