Need help?Do you have a question about the Lexicon 300 and is the answer not in the manual?
General| Digital I/O | AES/EBU |
|---|---|
| Display | LED |
| Effects | Reverb, Chorus, Flange, Delay, Pitch Shift |
| Inputs | 2 x XLR (Analog), 1 x AES/EBU (Digital) |
| Outputs | 2 x XLR (Analog), 1 x AES/EBU (Digital) |
| MIDI | Yes |
| Sample Rate | 48 kHz |
| Frequency Response | 20 Hz - 20 kHz |
| Dynamic Range | >90 dB |
| Control | Front panel controls, MIDI |
| Channels | 2 |
| THD+N | <0.05% |
| Power Supply | 100-240V, 50/60Hz |
| Reverb Algorithms | Plate |
Provides instructions for rack-mounting the 300 and details on its power specifications.
Details the rear panel connectors, including digital inputs/outputs, analog I/O, MIDI, and power.
Identifies and describes the function of each control on the 300's front panel.
Details the primary operating modes: Setup Select, Control, MACH, Setup Edit, Effect Edit, and Mod Edit.
Initial setup and default state of the 300, including loading presets.
Explains the three primary audio DSP routing configurations: Single, Dual Mono, and Cascade.
Details how to select analog or digital inputs and set the sampling rate.
Describes how to use Setup Edit, Effect Edit, and Mod Edit modes to modify parameters and patches.
Explains time code basics, formats, and how the 300 utilizes it for automation.
Details how to access, create, and manage time code triggered events.
Details standard MIDI connections using the IN, OUT, and THRU ports.
Addresses issues related to power supply fluctuations and operating temperature extremes.
Lists solutions for issues like no MIDI response or incorrect parameter changes.
Troubleshoots issues with time code not being recognized or changing effects too late.
Addresses problems with digital signal locking and audio output.
To Next Page
