300 "3.0 Owner’s Manual
Using the Softknob as a
Parameter Controller
Lexicon
The front panel Soft knob is primarily used to adjust dfferent parametervalues.
This Soft knob can also be programmed (in Mod Edit mode) as a multi-parameter
controller linking one or more parameters wfthin Setups and Effects. The control
portion of the Soft knob parameter is part of the Setup, and is set in Setup Select
mode. The PAGE UP and PAGE DOWN keys enable you to utilize the Soft knob
as a parameter controller.
Example:
Setup Preset DM 223 ‘Delay Daze contains two effect presets r3Voice Dlys and
*Pingo Pongo), each of which has delay parameters mapped to the Soft knob.
Load *Dly Daze, then press PAGE UP. The screen should display:
or
SoftknobA is the Soft knob value for Machine A
Softknob is the Soft knob value for Machine B
SoftknobS is the Soft knob value for Setup Parameters
Note the current Soft knobvalue (this particular Setup has a preset value Of 17):
and the labels for the effect parameters linked to the knob (DLY3 and DLY4 for
Soft knob A; DLYi, DLY2 and RDLY for Soft knob B).
Press VALUE to display the values of these effect parameters. Remember that
the display can only show one Machine’s effect at a time, to view parameters in
the other Machine which might be linked to the Soft knob, press MACH.
Leave the display in the value mode while turning the Soft knob on the front
panel, and you will see the displayed values change. The Soft knob parameter
has a range of 127 steps.
3-12
To Next Page
Loading...
