system operation
To enter Setup Select mode, simply press the front-panel key labeled SETUP
SetuP s&o~
SELECT. This mode has two pages of controls:
Page One allows selection of a setup. The upper line indicates “S:” (setup), a
preset (P)or register (R) number, and the setup name. The upper row of buttons
will step sequentially through the list of setups; turning the soft knob will scroll
through thelist. Afterfindingasetup you wanttoload, note its number. There are
two ways to load this setup:
Simply press ENTER while the number of the setup you want is selected on the
display. If this is not the current setup, the numberwill flash on the display. If you
do not press ENTER within afewseconds, the displaywill automatically change
back to the current setup. Pressing ENTER once the display has changed will
still load the selected setup.
or
Enterthe setup number you want on the numeric keypad to select a setup. Press
ENTER to load the setup.
Page Two:
This page displays the current Soft knob parameter value, as well as the SeW
parameters which are patched to it
Page Three:
This page displays the current Soft knob parametervalue, as well as the fi%?Cf
parameters which am patched to it.
3-11
To Next Page
Loading...
