Lexicon 300 - Front Panel Controls

3012 I3.0 Ovmer’s Manual
The Front Panel
MIDI and Sample
Rate LEDs
The amber MIDI LED
indicates activity over
the designated MIDI
channels. The sam-
piing rats of the 300 is
shown by the gree”
LED%
Level
Used to adjust Analog
input and output levels
(in conjunction with
the Soft knob and the
Page Up/Down keys).
Levels ars shown o”
the LED bar graphs di-
rect1y above the
LEVEL key. The lower
5 LEDs are green, fol-
lowed by 2 amber, and
one red ~ indicating
Lexicon
Page Up/Down
Allow access to dis-
play Pages of adjust-
able parameters.
Bypass
Enable digital bypass
of Machine A or B to
provide an unproc-
esssd signal, or to Power
mute the effect input.
Power OnJOff.
overioaa.
‘L\ -----l
Soft buttons /
Soft knob
/
Each of these eight
Used to adjust para-
buttons is used toss-
meters displayed and
lect the parameter
selected with the Soft
displayed directly
buttons.
above or below. Once
selected, parameters
can bechanged incre-
mentally by additional
button pushes, orthey
can be adjusted by
the Soft knob.
Numerical Keypad
Usedfornumericentty
of program numbers
(as an alternative to
Soft Knob selection)
and for time cnde en-
tries.
Dedicated-funotion keys
Setup Select: Used to
select and run setups.
Mach: In appropriate
configurations, allows
selection of either of
the 3OO’stwo procsss-
ing modules (Machine
A and Machine 6) for
front panel control.
Store: Used to rnerno-
rize effects and set-
ups.
Value:Usedtodisplay
parameter values for
Soft button or Soft
knob adjustment.
Control: Used to acv
cess system parame-
ters.
Setup Edft: Used to
create or mcde the
current setup.
Effect Edit: Used io
adjust the parameters
of effects.
Mod Edit: Used to _
create patches.