300 V 3.0 Owner’s Manuc~
Lexicon
Storing the Setup
3-16
Dual Mono Setups provide two Mix controls on Page Three: AMIX and BMlX.
These are independent mix controls for each machine.
Cascade Setups provide three Mix controls on Page Three: AMIX, BMIX and
OMIX.
AMIX varfes the amount of “dry” input in Machine A’s wet output. This Mixture
of wet and dry (ii any) is passed alongto the input of Machine B.
BMIX adjusts the proportion of Machine A’s wet output to the ‘wer’ output of
Machine B.
OMIX takes that mix result and mixes it with the “Dry” input signal.
The LFO (Low Frequency Qscillator) is a ccntrol generatorwhich is designed to
modulate Effect or Setup parameters in the 300 when parameters are patched
to it. The LFO has a shape and a rate (speed) function, available on Page Four.
The shape can be SlNEusoidal, TRIANGLE, SQUARE, or RANDOM. Rate is
adjustable from Off to 9.OHz.
.The action of the meters (FX-OUTforeither Left or Right channel) is determined
on Page Five.
Note: If you choose Left Meter or Right Meter as Patch sources when making
MOD Edits, you are essentially linkingthe ballisticsof the metertothedestination
parameter.
Pages Six and Seven allow you to make as many as two MOD patches in the
Setup domain.
On Page Eight you can name your Setup prior to storing it into a register. The
arrow (cursor) keys allow you to select a letter to change: the softknob actually
changes the character. The maximum length of a name is 12 characters.
When you have made all the necessary changes to a setup and want to save it
in a register, press STORE. The display will show:
The top line of the display shows the source (Src) -the currently selected Setup
name. The bottom line shows the destination (Dst) -the register number into
which the the setup will be copied. Use the Soft knob to select the register
number you want, then press STORE again. The display will return to the last
Setup Edit page.
Note:The300 has a memory protection feature which enablesordisabies
copying into the registers. When Copy Tools are disabled, all storingfunc
tions are inhibited. The Control mode Copy Tools page allows this feature
to beenabled or disabled. For more details, see the section describing
Control mode at the end of this chapter.
To Next Page
Loading...
