0
MIDI Out
The 300 can receive MIDI information on two independent channels: one for
SysEx and Dump messages, and one for Program Change and Dynamic MIDF’
patches. MIDI Channel assignments are made in Control mode. To select this
function, press CONTROL and use the PAGE UP/DOWN keys to display the
MIDI control page.
Pressing the button above “CHNL” will cause the following display to appear:
Press either of the left hand buttons in the lower row to select the MIDI Channel
for SysEx system and effect changes. Setup patch channel assignments are
also set here. Press either of the right hand buttons in the Upper row to select
the MIDI Channel for Dynamic MIDI@ parameter changes for Machine A. Press
either of the righthand buttons in the lower row for Machine B. (All selections
may, of course, be set to the same channel.)
MIDI Operation
300 with sequencer/computer
and keyboard
Setting MIDI Channels
7-3
To Next Page
Loading...
