Lexicon 300 - Mod Edit Mode

3130 V3.0 Owner’s Manual
Lexicon
Mod Edit Mode
Off
cntlr- 0
ModWheel
Breath
0lUr-3
FootPedal
Potta~me
Volume
cntlr-9
Pan
Expression
cntlr-12-15
GP CnUr-I-4
cnur-20-31
sustain
PataSW
SostenSw
SoftPedd
Switch-69-79
GP Cntlr-5-8
Sibzh-94-95
PitchWheel
AfterTouch
&tNOte
La&&l
MidiClock
Knob-,
L-Meter
R-Meter
LFO-I
Mod Edit mode is used to create or modii Dynamic MIDI* patches. To use
Dynamic MIDI@, you assign a MIDI controller or an event to a Setup parameter
or an effect parameter, using the patch parameters found on the pages in Mod
Edit. (Two pages for Setup patches are available in Setup Edit mode.) Four
parameter patch pages are available at any one time in Mod Ecft mode. The
pages will be for Machine A or Machine B, depending on the type of setup
currently running, and on the machine currently selected.
Each of the four available patch pages shows the following parameters:
Destination: This is used to select the effect parameter that the MlDt controller
is patched to. The available parameters are based on the algorfthm that you are
currently running.
Value: This is used to set the initial value of the parameter that you are
controlling. This is provided as a convenience so that you do not have to go into
Effect Edit mode to view the available parameters of the running algorithm.
Source: This is used to select the MIDI controiler, or event, that will control an
effect parameter in the 300. The list contains the selections shown to the left.
Threshold:Thisis used to set thecontrollervalue belowwhich thecontrollerwill
not have an effect on the parameter.
Scale: This is used to set the effective control range of the MIDI controller.
Scaling can be set from -200% to +200%. When Scale is set to lOO%, the full
range of the MIDI controller will cover the full range of the selected parameter.
Settinga negativevaluewillcausethe3OOto reducethesettingofthe parameter
as the controller increases.
Youcanstore anypatchesyoucreatewiththe Effect simplybypressing STORE,
selecting a register numberwfth the Soft knob, and then pressing STORE again.
Note: Se extremely careful when creating patches while a MIDI device
is connected. If you accidentally send a MIDI Program Change before
saving the patches in a register, they will be lost. To avoid this
possibility, you may want to set the MIDI Master Channel (in Control
Mode) to OFF, or unplug the MIDI cable from the 3Og’s rear-panel MIDI
IN connector.
3-20