Lexicon 300 - Page 43

Page Five
Naming the Setup
The bottom line of the display shows the name of the current setup, with acursor
positionedunderthefirst character.Thetwo keysdirectlyabovetheleftand right
arrows cause the cursor to move left and right to select other characters.
Pressing the key directly above “INS” adds a blank space wherever the cursor
is currently positioned in the display. Pressing the key directly above “DEY
removes the underscored character.
Turning the soft knob alters the underscored character. (Available characters
include: 0-9, a-z, A-Z, and an assortment of symbols.)
To rename the setup, simply position the cursor under the first character of the
current name, turn the softknob to replace this characterwith the first character
of the name you want, select the next character and change it, etc.
When you have made all the necessary changes to a setup and want to save it
in a register, press STORE. The display will show:
The toplineofthedisplayshows thesource (Src) -thecurrentlyselected setup
name. The bottom line shows the destination (IX) -the register number into
which the the setup will be copied. Use the Soft knob to select the register
number you want, then press STORE again. The display will return to the last
Setup Edit page.
Note: The 300 has a memory protection feature which enables or disables
copying into the registers. When Copy Tools are disabled, all storingfunc-
tions are inhibited. The Control mode Copy Tools page allows this feature
to beenabled or disabled. For more details, see the section describing
Control mode at the end of this chapter.
system operation
Storing the Setup
3-17