System Operation
Setup Edii mode is used to select the effect to be used in the setup. To enter
Setup Edit mode, first go to Setup Select mode and select and load the setup
!&tup Edit M&e
you want to modlly. With the setup selected, press SETUP EDIT.
The specific items available onthe various Setup Edii pages are determined by
the type of Setup (Single, Dual Mono or Cascade) which is loaded.
Page 1 shows the Effect which is loaded in the currently running Setup and
identifies the setup as SINGLE, DUAL MONO or CASCADE. The Effect ID
Single Setups
number is underscored, indicating that you can load new E!?ect Presets or
Registers. To s,elect another Effect, simply turn the softknob to cue up a new
Effect, then press ENTER.
Page One
Page 2 provides adjustment for analog and digital level and source balance into
the unified DSP engine. Simply press the key under the label of the control you
want to adjust and turn the softknob. As you turn the softknob, a long text
message will be displayed in the display. After a brief timeout, the display will
return to its orginal state.
Page Two
Note: Press VALUE to display parameter values rather than their labels. Once
you become familiar with the page layouts in the 300, you may find this mode
useful.
Single Setups have only one adjustable parameter on Page 3: OMIX. This
control adjusts the proporlion of “wet” signal to “dry”signal. Most SINGLE Setup
Presets have OMIX set to “WET” (100% wet effects).
3-13
To Next Page
Loading...
