2-5
Basic Operation
PCM 91
Selections of various system states and conditions are made in
Control Mode. Press Control to enter this mode. The Control
button LED will light to indicate that the mode is active. Note that
Control Mode functions are not available when the Compare
function is active.
The Control Mode matrix is shown above. Following are
descriptions of each available selection.
2 2.0 2.1 2.2
3 3.0 3.1 3.2 3.3 3.4
4 4.0 4.1
0 0.0 0.1 0.2 0.3 0.4 0.5 0.6
1.5 1.61 1.0 1.1 1.2 1.3 1.4
Audio
*Word Clock
1.7 1.8
3.5 3.6 3.7 3.8 3.9
System
Card
MIDI
Chain
Mapx
Setup
Analog In Lvl Dig In Lvl Word Size SCMS Emphasis Bit Output Level
Edit Mode Mix Mode Tempo Mode Bypass Mode Pgm Bypass Mem Protect Auto Load
Patch Update Initialize
Bank Copy Load Format
Reset Receive Transmit *Pgm Change Automation *Send Int Clock SysEx Dump Dump Speed
Map 0 Map 1
Chain
Pgm Assign
Chain 0 Chain 1 Chain 2 Chain 3 Chain 4 Chain 5 Chain 6 Chain 7 Chain 8 Chain 9
Store Load
Simultaneously press Up and Down to return to 0.0.
An asterisk (✱) accompanying a parameter name indicates available subparameters at that matrix
location. The Load/✱ LED will light when an asterisk appears on the display. Press Load/✱ to step
to the next subparameter. From any point in the matrix, press Up or Down together with Load/✱
to backstep to the previous parameter.
CONTROL MODE
To Next Page
Loading...
